Among the numerous Handcrafted beaded jewelry designs, when the mysterious black come across the clear and clean white, what will happen? Thus, in this strand of beaded bracelet, I will show you such an item. By the connected beaded patterns, you will do finish the project in half hours. Above all, take a look at the final product:

Things you may need in the beaded bracelet:

6mm Bicone Swarovski Crystal Bead (Black)

12/0 Glass Seed Bead

Hook clasp

Crimp bead

Bead Tip

Tiger tail wire

Side Cutting Plier

Wire-cutter Plier

How to take up the Handcrafted beaded jewelry designs?

Step1: design the basic component pattern

1. Snip 110cm lone tiger tail wire and fold it. At the folded location, attach on one bead tip by the Crimp bead. Then cross both working ends through one 12/0 seed bead as starting;

2. Add one 12/0 seed bead on each end and then cross both ends through another one 12/0 seed bead again;

3. Take up either of the working ends, string one 6mm Swarovski Crystal Bead and four 12/0 Seed Beads alternately; next, make a loop by using the four seed beads via pass back the wire through the first added one;

4. Repeat the above procedure for another end in beaded bracelet;

5. Add one 6mm Swarovski Bead on each wire and cross two ends through a 12/0 seed bead;

6. Repeat the process in picture.2 and tightly pull the working ends.

Step2: complete the main body portion of beaded bracelet 

Just repeat the above fundamental component one after one until getting an ideal length. At last, again add one bead tip on another tip.

Step3: final Handcrafted beaded jewelry designs

Hook on the hook clasp on two bead tips!

Tips: in the final Handcrafted beaded jewelry designs, you can adopt the ending way by hiding the wire but not normally knotting and trimming it. Try reserve longer tiger tail wire in beginning and in the ending work of beaded bracelet, just weave the adjoining beads in accordance with the basic beading methods. Just when passing through about 10 beads, the wire will never loose or disperse.